I believe that the friends who use the car often know that the car will definitely use the handbrake as long as the car is in use. Because the driver leaves the vehicle, if there is no hand brake, the vehicle may slip and may cause an accident. Sometimes, the handbrake has been pulled up, but the accident caused the failure of the brake system. Therefore, the majority of riders should regularly maintain and check the hand brakes of the car. The following small series introduces you to the precautions for the normal maintenance inspection of the hand brake. Make sure the handbrake handle is in the same position as the foot brake pedal. The handbrake handle also has a pull stroke. Usually, when the handle is pulled to 70% of the entire stroke, the handbrake system should be in the normal braking position, so before checking the braking force of the handbrake, you should first find this 70% working point, this working point can pass Count the ratchet sound to determine. You can park your car in a quiet place, slowly pull up the handbrake, and pull the ratchet of the ratchet until the handle is pulled to the end. Then calculate the 70% position of the total number of sounds, this position is the effective working point of the handbrake handle. Check the performance of the handbrake mechanism to drive the car to the slope with a large slope and good road surface (preferably asphalt road), step on the brakes, hang the neutral gear (if it is automatic shifting, hang it in the N gear), pull the handbrake handle to The location of the work point just identified. Then slowly release the brake pedal, if the car does not slip, it shows that the hand brake works well. Uphill and downhill should be done once. High-speed driving without a hand brake Many owners think that in the event of a brake system failure, the hand brake can be pulled to slow down. In fact, this is very dangerous. Since the hand brake mechanism is not precise, the braking force on the left and right sides is unevenly distributed. When the hand brake is pulled at a high speed, it is easy to lock the rear wheel on one side and slip. The correct way is to slow down by downshifting, and when the speed is very low, pull the handbrake to stop the car. Testing the sensitivity of the handbrake In addition to the braking performance, the sensitivity of the handbrake should also be checked, which is especially important for the start of the ramp. Slowly drive on a road with no slope, slowly lift the handle of the handbrake and feel the sensitivity and joint of the handle. This type of inspection will cause the handbrake mechanism to wear out, so the number of inspections should not be too much. During the inspection process, if the braking performance or sensitivity of the handbrake is found to be unsatisfactory, it can usually be solved by adjusting the operating cable of the handbrake. At the junction of the bottom of the handbrake handle and the cable (usually covered by the interior trim) there is an adjustable compensating mechanism that can be used to stretch the length of the brake cable by loosening the lock nut with a wrench. Some car’s adjustment mechanism is located at the bottom of the car. If it is not convenient to adjust, it should be handled by professional maintenance personnel.
April 28, 2019 0 Comments
- In the rainy season, the car is rust-proof and found to be rusted in time.
- The bigger the car, the more oily it is? Don’t be pitted by these mistakes
- Car problems These items do not need to be done in 4S shop
- Boao car maintenance monthly orders broke 10,000, the layout of the country 10 cities first
- Before the small holiday, it is necessary to “check the body” and change the season. The maintenance is not neglected.